115mm Thin Cutting Discs
The cutting disc belongs to the grinding wheel. It is made of abrasive and binder resin for cutting ordinary steel, stainless steel and non-metallic materials. It is divided into resin cutting disc and diamond cutting disc.
The 115mm thin cutting disc is a circular and flat blade made up of abrasive materials such as aluminum oxide or silicon carbide. It is designed to cut through various materials such as metal, stone, concrete, and masonry.
115mm thin cutting discs structure
Abrasive Grains
Aluminum oxide, silicon carbide, monocrystalline fused alumina, ceramic abrasives, etc.are used,in order to make them suitable for different purposes.
Bond
Durable bond enhances the resistance to side pressure and bending, thus increasing durability
Additives
Increase the toughness, hardness and durability of the cutting discs
Metal ring
Strong metal ring will not fall off from the machine during usage. And will not get rusted due to the special coating on the surface.
The most suitable fiberglass mesh is used according to your requirements.
1. Select raw material sand. The incision is smooth and burr-free, the cutting is smooth, and the workpiece is not easy to burn.
2. Reinforced mesh, safe, environmentally friendly and wear-resistant.
3. Stainless iron grommet, fixed firmly, not easy to fall off.
4. The decay rate is low, sealed with LDPE low-density film to isolate the oxidation reaction between the grinding wheel and the air. Significantly extend the service life and storage life of the grinding wheel
The 115mm thin cutting disc can be used with an angle grinder or a cut-off saw. The blade is mounted on the tool and rotated at a high speed to make cuts through the material being worked on. It is important to use the right speed and pressure when cutting to prevent damage to the blade and ensure a clean, precise cut.
Precautions
1. When wet cutting, an isolation transformer is required.
2. When installing or removing the saw blade, be sure to disconnect the urgent power cord plug.
3. When in use, the diameter of the inner hole of the cutting piece is consistent with the diameter of the machine shaft
It is forbidden to change the internal control diameter of the saw blade without permission.
4. When operating, only straight and right-angle cutting can be performed, do not bend the cutting to avoid the saw blade cracking
Do not let the saw blade overheat, stop work at an appropriate time to cool the saw blade.
Wear safety helmets, protective glasses, overalls and gloves during operation to ensure safety
We can custimized the packing according your requirement .
we usually pack in small box, plastic drum or color iron box. and then in carton and then pack in pallet
small box, iron box and carton can be customized but there is moq requirement
shipping can by sea / air /train. you can choose the way which is most convenient to you. to door service we also provide
Hot Tags: 115mm thin cutting discs, China 115mm thin cutting discs manufacturer, suppliers, factory, 400 grit wet sandpaper, abrasive products, nylon cup brush, 10000 grit sandpaper, 2x48 sanding belts, wood sanding disc for angle grinder
